How to Guide

6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
Figure 4
SET
Dip Switch
14
How to Operate Your Ceiling Fan (continued)
• Sleep Timer:
The fan and light will turn off after 1 hour.
The fan and light will turn off after 3 hours.
The fan and light will turn off after 6 hours.
7. Remote functions: (Figure 5)
• Indicator LED light: fan speed and light
dimmer indicator
• Fan Speed:
• button: Tap once to turn off the fan. Press and
hold this button for 5 seconds to turn on or turn off
the buzzer.
• Light button: Turn ON\OFF the light.
Turn on fan and turn speed up.
Turn on fan and turn speed down.
Increase light output level.
Decrease light output level.
Figure 5
• Home Away: Tap this button, the light will
blink twice signaling this feature is on; the fan
will turn off and the light will randomly turn on
and off while you are away. Pressing any button
will cancel the feature.
• Safe Exit: Tap once, the light will blink once;
fan and light will turn off after 1 minute. Pressing
any button will cancel this feature.
• Reverse button:
Summer- The fan runs counterclockwise.
Airflow will provide a downward cooling breeze.
Winter- The fan runs clockwise. Airflow will force
warm air downward without a noticeable breeze.
• Fresh Air: Fan speed will modulate to
simulate a natural breeze.
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch that
controls the power supply is moved to the on position,
press and hold the “SET” button inside of the battery
compartment of the handheld remote control for 1-3
seconds.
2) You must press the “SET” button within 30 seconds of
restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the hand-
held remote control before pressing the “SET” button,
otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the “SET” button, please turn the
wall switch that controls the power to the fan to the o
position then on again, and start the process beginning
with Step 1 above.
5) When you press the "SET" button, the fan will make
one musical sound and light blink once and start to run
beginning the control set up process.
6) DO NOT press any button(s) after pressing the SET
button while the fan is programming or it will fail to
program.
NOTE: If you want to change the blades: turn
the power off→ change the blades→ turn the
power on→ perform the control setting process.
7) The fan will run in forward direction for approximately
3 minutes.
8) When the fan stops running after approximately 3
minutes, the fan will make two musical sounds and light
blink twice that means that handheld remote control and
speed set up process is complete.
9) The fan is now ready for normal use.