Installation Guide

Main Fuse Box
Hanger Bracket
Receiver
Dip Switch
NOTE: Supply wires
omitted for clarity
Receiver
How to Wire Your Ceiling Fan
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION
COULD DAMAGE THIS RECEIVER.
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
Black
White
L
N
AC
POWER
Red
Gray
Yellow
Yellow /
green
Ground
Hanger
Bracket
Hanger
Ball
DC MOTOR
Black Antenna
Receiver
Blue
Black /
White
2. Slide the receiver into the hanger bracket before
wiring as shown in figure 3.
3. Connect wires using connectors as shown in
Figure 4.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
Wire Connectors
RECEIVER HARDWARE USED:
X 8
Figure 1
Figure 2
Figure 4
Dip Switch
ON
1 2 3 4 5
Figure 3
10