Installation Guide

11
How to Assemble the Light Kit (continued)
4 (Option A--for use with light kit)
Insert light bulb into socket. (Figure 4A)
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
4 (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light plate assembly by
twisting in a clockwise direction. (Figure 4B)
NOTE:
If you have installed your fan with the steel cap,
skip steps 5.
5. Secure the glass to light plate assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 5)
3V, CR2032
BATTERY
2PCS
REMOTE
CONTROL
How to Operate Your Ceiling Fan
Figure 3
Figure 1
Figure 2
MAIN FUSE BOX
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 2).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
WARNING
For illustrative purposes only-not
intended to cover all types of controls
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Figure 4A Figure 4B
Socket Plate
Light Plate
Assembly
Assembly
Light Bulb
Steel Cap
Assembly
Light Plate
Assembly
Glass
Figure 5
3. Operating and using hand-held remote (Figure 3):
Install two 3-volt batteries (included). If not using for
long periods of time, remove battery to prevent damage
to transmitter. Store the hand-held remote away from
excessheat or humidity.