Installation Guide

Figure 3

Ceiling Bracket Assembly

2. Remove the four screws and hex nuts with flat washer

from the ceiling bracket assembly. Retain the screws, hex

nuts and flat washers for later. (Figure 3)

How to Hang Your Ceiling Fan

1. Securely attach the ceiling junction box acceptable for

ceiling support into the building structure. Junction box

is not supplied with the fan. (Figure 2)

WARNING

It is critical that the outlet box and the screws are

securely anchored to the building structure and capable

of withstanding a load of at least 35 lbs. Failure to verify

that the screws are properly installed could result in the

fan falling. (Figure 2)

Figure 1

WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before hanging.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

WARNING

The fan must be hung with at least 7´ of clearance from

floor to blades. (Figure 1)

Floor

Ceiling

less than

7 ft

Figure 2

NOTE: Supply wires

omitted for clarity

Outlet Box

3. Using the ceiling junction box screws provided with the

ceiling junction box, securely attach the ceiling bracket to

the ceiling junction box as shown. (Figure 4)

4. Hang the Motor Assembly as shown. (Figure 5) You can

now proceed with the electrical wiring of your fan.

Junction Box

Motor Assembly

Screws (2)

Figure 4

Figure 5