Owner's Manual

How to Hang and Wire Your Ceiling Fan (continued)
x 4WIRE
CONNECTORS
HARDWARE USED:
7.
After splicing and making the wire connections, the
wires should be spread apart and turned upward with
the grounded conductor (white), the equipment
-grounding conductor (green) and safety cable on one
side of the ceiling bracket and the ungrounded conductor
(black and blue) on the other side of the ceiling bracket.
(Figure 5)
6. Connect wires using connectors as shown in
Figure 5.
Figure 4
Receiver Unit
Dip Switch
ON DIP
1 2 3 4 5
8
5. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 4)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this position.
Figure 5
White Wire
from Supply
Green Wire
from Ceiling
Bracket
White wire
from Receiver
BLK_ANT
Blue Wire
from Motor
Black Wire
from Motor
Black Wire
from Receiver
White Wire
from Receiver
Blue Wire
from Receiver
Black Wire
from Receiver
White wire
from Motor
Green Wire
from Supply
Black Wire
from Supply