Installation Guide
7
How to Hang Your Ceiling Fan (continued)
Figure 5
Ceiling Bracket
Assembly
Motor
Assembly
4. Hang the Motor Assembly as shown. (Figure 5)
You can now proceed with the electrical wiring of
your fan.
Figure 1
Figure 2
MAIN FUSE BOX
NOTE:
If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
How to Wire Your Ceiling Fan - Wall Control
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by
a licensed electrician.
▲
WARNING
To avoid possible electrical shock, be sure electricityis
turned off at the main fuse box before wiring (Figure 1).
NOTE: Supply wires
omitted for clarity
1. Disconnect the power and remove the existing
wall plate and switch.
2. Set the knob and light switch of the wall-mounted
control in the off (0) position.
3. Make wire connections and secure with wire nuts
supplied. (Figure 2)
Connect the Black wire (AC IN L) from the
wall-mounted control with the wire from the A. C.
power supply.
Connect the White wire from the ceiling fan to
the A. C. power supply.
Connect the Black wire (To Motor L) from the
wall-mounted control with the Black wire from the
ceiling fan.
Connect the Blue wire (To Light) from the
wall-mounted control with the Blue wire from the
ceiling fan.
Connect the green/yellow wire from the
wall-mounted control with ceiling fan and ground wire
from the A. C. power supply.
WARNING
Black
Black
Black
Black
White
Ground
Green
Blue
Blue
Green/Yellow
120V AC
SUPPLY
SOURCE
AC IN L
To Light
To Motor L
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
NOTE:
Please set all knobs on the fan/light control in the
off (0) position before wiring.