Owner Manual

ManualsBrandsFanimation ManualsAll Ceiling Fans52" Aire Deluxe 5 Blade Ceiling Fan with Remote, Light Kit Included

14

Trouble Shooting

For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.

WARNING

Trouble Probable Cause Suggested Remedy

1.FAN WILL

NOT START

1. Check main and branch circuit fuses

or circuit breakers.

2. Check line wire connections to fan

and switch wire connections in the

switch housings.

CAUTION: Make sure main power is

turned off !

1. Fuse or circuit breaker blown.

2. Loose power line connections to the

fan, or loose switch wire connections

in the switch housing.

2.FAN SOUNDS NOISY

1. Attach blades to fan before operating.

2. Check to make sure all screws in

motor housing are snug (not over-

tight).

3. Check to make sure the screws which

attach the fan blade holders to the

motor flywheel are tight.

4. Check to make sure wire connectors

in switch housing are not rattling

against each other or against the

interior wall of the switch housing.

CAUTION: Make sure main power is

turned off !

5. Tighten screws securely.

1. Blades not attached to fan.

2. Loose screws in motor housing.

3. Screws securing fan blade holders to

motor flywheel are loose.

4. Wire connectors inside housing

rattling.

5. Screws holding blades to blade

holders are loose.

3.FAN WOBBLES

EXCESSIVELY

1. Tighten both setscrews securely in

downrod support.

2. Tighten the setscrew in the downrod/

hanger ball assembly.

3. Check to be sure screws which attach

the fan blade holders to the flywheel

are tight.

4. Check to be sure the fan blade

holders seat firmly and uniformly to

the surface of the motor housing.

If holders are seated incorrectly,

loosen the screws and retighten.

5. Tighten the hanger bracket screws to

the outlet box, and secure outlet box.

6. Balance blades using balance kit

provided in hardware bag.

1. Setscrew in downrod support is loose.

2. Setscrew in downrod/hanger ball

assembly is loose.

3. Screws securing fan blade holders to

flywheel are loose.

4. Blade holders not seated properly.

5. Hanger bracket and/or ceiling outlet

box is not securely fastened.

6. Fan blades out of balance.

4.NOT ENOUGH AIR

MOVEMENT

1. If possible, consider using a longer

downrod (not included, you can buy

the longer downrod from

fanimation.com).

6. Lower housing support set screw

loose.

6. Tighten set screw securely.

3. Make sure reversing switch position is

all the way to one side.

3. Reversing switch in neutral position.