Owner Manual

14
How to Operate Your Ceiling Fan (Continued)
3. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting process.
If not used for long periods of time, remove battery to
prevent damage to transmitter. Store the remote away
from excessive heat or humidly. (Figure 3)
6. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 4)
3V, CR2032
BATTERY
3V, CR2032
BATTERY
Figure 3
3V CR2032
Battery (2 pcs)
Figure 4
SET
Dip Switch
4. If you have multiple fans and want to program all fans
to one handheld control, connect all fans to their power
supply in the ceiling and follow Step 1 of the remote
control set up process. Each fan needs to be no more than
30 feet from the handheld control that you would like to
program. Please note the wall switch that controls the
power to your fan(s) should be in the off position until you
are ready to program your handheld remote(s).
5. If you have multiple fans and want to program each fan
to separate handheld controls, connect one fan at a time to
their power supply in the ceiling and follow Step 1 of the
remote control set up process below. Before you connect
the second fan to its power supply in the ceiling, you must
disconnect the first fan that was wired and programmed
from the power supply in the ceiling. Repeat these steps
for each fan that you would like to program to a separate
handheld remote. Please note that the wall switch that
controls the power to your fan(s) should be in the off
position until you are ready to program your handheld
remote(s).
1) After installing and wiring the unit, restore power to your
fan by ensuring that the breaker and wall switch that
controls the power supply is moved to the on position,
press and hold the “SET” button inside of the battery
compartment of the handheld remote control for 1-3
seconds.
2) You must press the “SET” button within 30 seconds of
restoring power to the fan.
3) When restoring power to your fan at the wall switch and
breaker, DO NOT press any button(s) on the
handheld remote control before pressing the “SET” button,
otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the “SET” button, please turn the
wall switch that controls the power to the fan to the o
position then on again, and start the process beginning
with Step 1 above.
5) When you press the “SET” button the fan will make two
musical sound and light will blink twice, and it has finished
the control set up process.
6) The fan is now ready for normal use.