The Torto ™ Ceiling Fan Net Weight 12.46 kg (27.4 lbs) Model No.
Important Safety Instructions WARNING: To avoid fire, shock and serious personal injury, follow these instructions. 1. Read your owner’s manual and safety information before installing your new fan. Review the accompanying assembly diagrams. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally.
This Manual is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate, and Maintain Your Ceiling Fan Tools Needed for Assembly • One Phillips head screwdriver • One stepladder • One ¼" blade screwdriver Materials • One wire stripper • Three wire connectors (supplied) Wiring outlet box and box connectors must be of type required by local code. The minimum wire would be a 3conductor (2-wire with ground) of the following size: Installed Wire Length ▲WARNING Up to 50 ft.
Electrical and Structural Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations that may be used for mounting the outlet box. Ceiling ▲WARNING Ceiling Joists To reduce the risk of fire, electrical shock, or personal injury, mount fan to outlet box marked acceptable for fan support.
How to Assemble Your Ceiling Fan (cont’d) 3. Loosen the two setscrews in the Downrod Support. Align the Clevis Pin holes in the Downrod with the holes in the Downrod Support. Install the Clevis Pin and secure with the Hairpin Clip. (Figure 2) Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose.
How to Hang Your Ceiling Fan ▲WARNING No less than 18 inches To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before hanging. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.
How to Wire Your Ceiling Fan - C20 Remote Control If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a quali�ed electrician. GRN from hanger bracket GRN from downrod ▲WARNING To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
Final Fan Assembly CAUTION To avoid possible electrical shock, be sure electricity is turned off before installing downlight assembly. 1. Securely attach plugs from motor to sockets on Downlight Socket Plate Assembly (Figure 1) Figure 1 2. Securely attach Downlight Socket Plate Assembly to the Adapter Plate by tightening three screws provided with the fan. (Figure 2) Figure 2 3. Install two Candelabra Bulbs (included - 60 watts max) in each of the sockets on the Downlight Socket Plate Assembly.
Operating Instructions - C20 Remote Control 1. Operating & Using Remote Transmitter (Figure 1): Install 9 volt battery (If not using for long periods of time, remove battery to prevent damage to transmitter). Store the transmitter away from excess heat or humidity.
Parts List Model #FP7900** Ref. # Description 1 Hanger Bracket Assembly with Shoulder Screws (2) 2 Downrod/Hanger Ball Assembly Containing: 2a Hanger Ball Assembly 2b Downrod 2c Clevis Pin 2d Hairpin Clip Part # APG255 ADR1-6** 3 Ceiling Canopy 3a Canopy Screw Cover APPFM1101 PG165** 4 Motor Coupling Cover AP790007** 5 Fan Motor AMA7900** 6 Downlight Socket Plate Assembly AP790010** 7 Candelabra Bulbs, 60 watts (2) 8 Glass, Light Kit P790003OP 9 Blade Asm.
The Torto™ FP7900 Exploded-View 1 1 2a 2a 2b 2b 2 2 3 10 2c 2c 2d 2d 3 3a 11 4 5 12 6 9 7 8 Figure 1 NOTE: The illustration shown is not to scale or its actual configuration or finish may vary 11
Copyright 2008 Fanimation 10983 Bennett Parkway Zionsville, IN 46077 Toll Free (888) 567-2055 FAX (866) 482-5215 Outside U.S. call (317) 733-4113 Visit Our Website www.fanimation.
