Owner Manual

12
How to Assemble the Blades and Light Kit (continued)
SOCKET PLATE
ASSEMBLY
SOCKET PLATE 2-PIN
CONNECTOR
Figure 4
Figure 5
LIGHT SOCKET
50-WATT
MINICAN
LIGHT BULBS (2)
Figure 6
4. Connect the 2-pin connector from the socket
plate to 2-pin connector from motor assembly
(Figure 4).
6. Insert light bulbs into sockets (Figure 6).
FROSTED
GLASS
GLASS SUPPORT NUT
RUBBER WASHER
FINIAL NUT
Figure 7
7. Remove finial nut, glass support nut, and rubber
washer from threaded post on socket plate.
Postion glass onto Socket Plate Post and secure
with rubber washer and glass support nut
Assemble finial nut onto threaded shaft.
Do not over-tighten (Figure 7).
5. Remove one of the three screws in the housing
light kit assembly. Slightly loosen the remaining
two screws. Assemble the socket plate to the
light plate assembly using the two key slots.
Replace the third screw and securely tighten all
three screws (Figure 5).
MOTOR ASSEMBLY
2-PIN CONNECTOR
SCREWS (3)
SOCKET PLATE
LIGHT PLATE
ASSEMBLY