Owner Manual

13
How to Operate Your Ceiling Fan
MAIN FUSE BOX
Figure 2
Figure 1
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 2).
4. The 5-button hand-held remote transmitter includes
five buttons for high, medium and low fan speeds
as well as fan off and light on/off. Infinite light levels
are available by holding the light on/off button
(Figure 4).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
REVERSE
SWITCH
5. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Then slide the reverse switch on top of motor
assembly to the opposite position and turn fan on
again (Figure 5).
Reverse Switch Information
Season Rotation Direction Switch Position
Summer Counter-Clockwise Left
Winter Clockwise Right
3. To make fan operational, install two piece of 3-volt
battery in hand-held remote transmitter, (if not using
for long periods of time, remove battery to prevent
damage to transmitter). Store the remote away
from excessive heat or humidly (Figure 3).
Figure 3
REMOTE
3V, CR2032
BATTERY
2 PCS
CONTROL
Figure 4
5-BUTTON
REMOTE
CONTROL
Figure 5
For illustrative purposes only-not
intended to cover all types of controls
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
WARNING