Installation Guide

LK179** Wet Light Kit Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
Weight: 2.53 lbs (1.15 kgs)
NOTE: This ceiling fan light kit is only meant to be used with ceiling fans. Do NOT install as
a light fixture.
WARNING:
To reduce the risk of fire or electric shock, do not use this fan/light kit with any
solid-state speed control device.
To reduce the risk of fire and electric shock, this kight kit
should be used only with the fan model listed below:
CAUTION CAUTION
at the main fuse box to the fan before installing the light
kit.
Fan Model: TF910
2. Remove cover switch housing and
retain the screws for Step 7.
3. Remove threaded plug from cover
switch housing.
Cover Switch
Housing
4. Route wires from light kit through the
supplied large rubber washer, then through
the switch housing and secure cover
switch housing to light kit with lockwasher
and nut provided.
Cover Switch
Housing
Light Kit
5. Locate white and blue wires labeled
“FOR LIGHT”.
6. Connect white-to-white and blue-to
-black wires with wire nuts.
7. Assemble the light kit onto the motor
assembly using the previously removed
screws.
Light Kit
8. Secure the glass to light kit by twisting
in a clockwise direction.
Do not over-tighten.
Light Kit
Glass
1. Slide the switch to "RC" if you are using
remote control or wall control with the
light kit. Slide the Switch to "CH" if you
are using pull chain with the light kit.
9. Check the operation of the light kit
by gently pulling on the pull chain.
• 1
st
Pull= On
• 2
nd
Pull= Begins dimming
• 3
rd
Pull= Stops dimming
• 4
th
Pull= Off