Installation Guide

1. Remove the steel cap from motor
assembly.
2. Remove one of the three screws in
the light kit wire cover assembly at the
bottom of the light plate assembly and
retain the screw for Step 4. Slightly
loosen the remaining two screws and
remove the light kit wire cover assembly.
NOTE: This ceiling fan light kit is only meant to be used with Kute 44
™
or Kute 52
™
ceiling fans.
Do NOT install as a light fixture.
NOTE: Installation shall be in accordance with the National Electrical Code, ANSI/NFPA 70 and
local codes.
WARNING: To reduce the risk of fire or electric shock, or injury to persons, unplug or disconnect
the appliance from the power supply before cleaning, user maintenance and servicing.
To reduce the risk of fire and electric shock, this kight kit
should be used only with the Kute 44
™
or Kute 52
™
Fanimation Fan Models.
Turning off wall switch is not sufficient. To reduce the risk
of fire and electrical shock, be sure electricity is turned off
at the main fuse box to the fan before installing the light kit.
Steel Cap
Motor
Assembly
Light Kit Wire
Cover Assembly
Motor
Assembly
3. Connect the 2 single pin connectors
from the light
kit assembly to the 2 single
pin connectors from motor assembly.
Light Kit
Assembly
Light Shade
5. Secure the light shade to the light kit
assembly by twisting in a clockwise
direction. Do not over-tighten.
Light Plate
Assembly
Light Kit
Assembly
Light Plate
Assembly
4. Assemble the light kit assembly to the
light plate assembly using the two key
slots in the light kit assembly, replacing
the previously removed screw and
securely tightening all three screws.
CAUTION CAUTION
LK8534** Light Kit Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
Weight: 0.40 lbs (0.18 kgs)
Light Kit
Assembly