User Manual

Assembling and Mounting the Fan BladesAssembling and Mounting the Fan Blades (Continued)

NOTE: Periodically check Blade Holder hardware and re-

secure if necessary. (see Maintenance below)

WARNING

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades or

cleaning the fan. Do not insert foreign objects in between

the rotating blades.

2. Attach blade holders to the bottom of the fan motor

hub using the ¼Ý–20 x 11 mm screws w/lockwashers.

Make sure the screws with lockwashers securing

the blade holders to the fan

motor hub are tight and

that the blade holders are properly seated. (Figure 17)

Figure 18

Switch Housing Cup Assembly:

3. Disassemble the Switch Housing Cup Assembly by

removing three screws and retain for use in step 5.

(Figure 18)

Figure 19

Remove one of the three screws in the support

bracket at the bottom of the motor assembly.

Slightly loosen the remaining two screws.

Assemble the light plate assembly to the

support

bracket using the two key slots in the socket plate

Replace the third screw and securely tighten all three

screws (Figure 19).

x 10

1/4Ŋ-20 x 11 mm

SCREWS

HARDWARE USED:

Figure 17

Socket-Head

Screw with Lockwasher

(2 per blade holder)

5. ehtotnopuChctiwSgnisuoHehtelbmessA

assembled Adapter with the three screws retained in

step 1. (Figure 20)

Figure 20