Installation Manual

21
Filters and ERV core washing instructions
For proper maintenance of your energy recovery core please follow these instructions
7
8
5
6
2
1 To remove the door, remove locking screw
and washer on the side of the unit.
2 Remove both lters.Wash lters in warm
soapy water then rinse and let dry.
3 Rotate the metal plate holding the ERV core
in place.
4 Remove the core from the unit.
5 With one of your core's air inlets facing
down, place it in a large sink, bathtub, or
shower.
6 Pour clean tap water through the face of the
core facing upwards until it runs clear.
Ensure the entire surface is rinsed.
7 Rotate the core so that its other air inlet is
facing down and repeat step 5.
8 With plates still oriented vertically allow the
core to dry, normally 2-3 hours.
9 Slide back the core into the system making
sure that the arrow points to the motors.
Rotate the metal plate holding the ERV Core
in place.
10 Replace the lter.
11 Close door and secure with locking screw
and washer.
1
3
10
9
11