Grass Trimmer OWNER’S MANUAL Model PT180H 120V., 60Hz., 3.8 Amps CAUTION Before using this Grass Trimmer, read this manual and follow all its Safety Rules and Operating Instructions. • Safety Instructions • Accessories • Assembly • Operation • Maintenance FANTOM, 94 Main Mill Street, Door 16, Plattsburgh, N.Y. 12901 Tel.
SAFETY & WARNING INSTRUCTIONS WARNING! THIS MACHINE CAN CAUSE SERIOUS INJURIES. When using the Grass Trimmer basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. Carefully read and understand the entire owner’s manual before using your Grass Trimmer. Pay close attention to the Operating Instructions and Safety Warnings. Be thoroughly familiar with the controls and the proper use of this unit.
OPERATING INSTRUCTIONS Care, Maintenance & Storage WARNING: To avoid serious 4. personal injury, be sure that the power cord is removed before cleaning or performing any kind of maintenance on the grass trimmer. Your grass trimmer has been designed to operate with a minimum amount of maintenance. Continuous satisfactory operation depends on proper tool care and regular cleaning. 1. Remove the power cord from the unit. 2. Regularly clean the ventilation slots using a soft brush or dry cloth.
SAFETY & WARNING INSTRUCTIONS 42. Use the grass trimmer ONLY in the upright position, with the cutting line near the ground as shown in the instruction manual. Never use the grass trimmer in any other position. 43. Do not work on a steep slope, always be sure of your footing. Please note that freshly cut grass is damp and slippery. 44. Use only the trimmer line supplied by the manufacturer. Never use metal cutting or fishing line. 45.
OPERATING INSTRUCTIONS Using the Grass Trimmer as an Edging Tool To convert the grass trimmer to an edging tool: 1. Attach the extension cord to the grass trimmer. 2. Press the hand grip release button and turn the hand grip 180° counter clockwise. (Fig. 9) 3. Loosen the handle locking nut and turn the handle 180° clockwise also. Adjust this handle to a comfortable position to hold. (Fig. 9) 4. Press the safety trigger interlock and then squeeze the “On/Off” trigger. 3.
OPERATING INSTRUCTIONS Attaching the Cutting Guard WARNING: Do not connect the Handle Assembly WARNING: Do not connect the grass trimmer to the power source before the unit is completely assembled. 1. Place the unit on a flat surface. 2. Loosen and remove the locking nut from the handle. 3. Firmly push the handle over the shaft. (Fig. 1) 4. Adjust the handle to the most comfortable position. 5. Pass the bolt through the handle. 6. Screw in the locking nut into the bolt. Do not over tighten the bolt. (Fig.
