PRESSURE WASHER OWNER'S MANUAL Model VPW46H 120V., 60 Hz., 13 Amps. FANTOM 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 Tel.
SAFETY & WARNING INSTRUCTIONS For safety reasons, it is recommended that you read this manual before attempting to operate this appliance. Failure to follow these instructions can result in personal injury or equipment problems. To help recognize note the following symbols: 9. Keep operation area clear of all persons. 10. Do not overreach or stand on unstable support. Keep good footing and balance at all times. 11. Follow maintenance instructions specified in this manual. 12.
SAFETY & WARNING INSTRUCTIONS TROUBLE SHOOTING PROBLEM POSSIBLE REASON PRESSURE WASHER WILL NOT START WHEN THE ON/OFF SWITCH IS IN THE "ON" POSITION 1. PUMP DOESN'T REACH ADEQUATE PRESSURE OR CAVITATES 1. 2. 3. 2. 3. 4. Electrical socket is faulty or breaker has tripped. Voltage is inadequate. GFCI has tripped. Power cord is not plugged in. 1. 2. 3. 4. 1.
GETTING TO KNOW YOUR PRESSURE WASHER OPERATING INSTRUCTIONS Maintenance & Cleaning Winterizing & Long Term Storage 1. Disconnect all water connections. 2. Turn the pressure washer on for a few seconds, until any remaining water in the pump exits. 3. Turn the unit off immediately. 4. Store the pressure washer, parts and accessories in an area with a temperature above 32°F. Lubrication: The pressure washer is supplied with a closed lubrication system, so no addition of oil is needed.
OPERATING INSTRUCTIONS CAUTION Fig. 15 When you wish to stop using the pressure washer temporarily, make sure that the safety lock has been engaged to avoid any accidental operation. (Fig. 12) Fig. 12 OPERATING INSTRUCTIONS Using the Drain Snake With the Trigger Gun The drain snake is used with the trigger gun to help clean blockages in sewer/waster piping by the use of a high pressure water jet and turbulence.
Assembling the Pressure Washer OPERATING INSTRUCTIONS Attaching High Pressure Hose to Pressure Washer Fig. 3 Fig. 4 Once all the desired attachments and the high pressure hose are attached to the pressure washer, you can connect the garden hose to the unit. 1. Make sure that the water intake filter is inside the water intake inlet. (Fig. 11) 2. Attach the male adapter (supplied) to the water intake connector on the front side of the unit. (Fig. 11) 3. Attach the female hose coupling to the garden hose.
