User's Manual

114
11.39 Security Settings
Picture 96- Input and output settings
Security Settings
parameter
description
Basic Settings
Ringtone
Duration
The duration of the alarm bell
Input &
Tamper
Server
Address
Configure the remote response server address (including the remote
response server address and the alarm trigger server address). When the
input port is triggered, a short message will be sent to the server, the
message format is as follows:
Alarm_Info:Description=i51;SIP
User=;Mac=0c:38:3e:39:6a:b6;IP=172.16.7.189;port=Input
Input Settings
Input
Enable or disable the input port
Triggered By
When low level trigger (closed trigger) is selected, the detection input port
(low level) closed trigger.
When the high level trigger (disconnect trigger) is selected, the detection
input port (high level) disconnect trigger.
Send SMS
Enable or disable the input port to send messages to the server
Dss Key
When set to dsskey1 or dsskey2, trigger dsskey to make a call, the default is
none
Triggered
Ringtone
Support ringtone selection
Table 32 - Input and output parameters