User's Manual

24
7.6 Network Configurations
The i53W device supports two network connection methods: wired network connection
and wireless network connection. Users need to choose the corresponding connection
method according to their own situation.
The device uses an IP network connection to provide services. Unlike traditional devices
based on line circuit technology, IP devices are connected to each other through the
network to exchange data packets and data based on the device's IP address.
To enable the device, the network configuration must first be properly configured. To
configure the network, users need to find the device function menu button [Menu] >>
[Advanced Settings] >> [Network] >> [Network Settings].
The default password for entering advanced settings is "123".
NOTICE! If user saw a ‘WAN Disconnected’ icon flashing in the middle of
screen, it means the network cable was not correctly connected to the device’s
network port. Please check the cable is connected correctly to the device and to
the network switch, router, or modem.
The device supports three network types, IPv4/IPv6/IPv4&IPv6
There are three common IP configuration types for IPv4
 DHCP – This is the mode that automatically obtains the network configuration from
the server. The user does not need to manually configure any parameters. Suitable
for most users.
 Static IP configuration – This option allows users to manually configure each IP
parameter, including IP address, mask, gateway and primary DNS server and
backup DNS server. This usually applies to some professional network user
environments.
 PPPoE – This option is usually suitable for users who connect to the network
through a broadband service account. To establish a PPPoE connection, the user
should provide the user name and password provided by the operator.
 The default configuration of the device is the network mode of automatic
configuration

 There are two common IP configuration types for IPv6
 DHCP – This is the mode that automatically obtains the network configuration from
the server. The user does not need to manually configure any parameters. Suitable