User's Manual

39
user to send a Real Time Transport Protocol (RTP) stream to the pre-configured
multicast address without involving SIP signaling. You can also configure the phone to
receive an RTP stream from pre-configured multicast listening address without involving
SIP signaling. You can specify up to 10 multicast listening addresses.
Picture 32- Multicast Settings Page
Table 14 - MCAST Parameters on Web
Parameters
Description
Normal Call Priority
Define the priority of the active call, 1 is the
highest priority, 10 is the lowest.
Enable Page Priority
The voice call in progress shall take precedence
over all incoming paging calls.
Name
Listened multicast server name
Host: port
Listened multicast server’s multicast IP address
and port.
Multicast：

Go to web page of [Function Key] >> [Function Key] , select the type to
multicast, set the multicast address, and select the codec.

Click Apply.

Set up the name, host and port of the receiving multicast on the web page of
[Phone Settings] >> [MCAST].

Press the DSSKEY of Multicast Key which you set.