User Manual

13
/
42
5 Phone Settings
In order to get the device ready for making and receiving phone calls, the device must be configured with
correct network configurations and at least one of the lines must be configured with an SIP telephony service.
The SIP must be configured properly to be able to provide telephony service.
5.1 Getting IP address
DHCP is the default setting in Network, and telephone will get the IP address from DHCP server(Router)
after the line connected.
There are three common IP configuration modes.

Dynamic Host Configuration Protocol (DHCP) – This is the automatic configuration mode by getting
network configurations from a DHCP server. Users need not to configure any parameters manually. All
configuration parameters will be getting from DHCP server and applied to the device. This is
recommended for most users.

Static IP Configuration – This option allows user to configure each IP parameters manually, including IP
Address, Subnet Mask, Default Gateway, and DNS servers. This is usually used in an office environment
or by power users.

PPPoE – This option is often used by users who connect the device to a broadband modem or router. To
establish a PPPoE connection, user should configure username and password provided by the service
provider.
5.2 Checking IP address
Pick up the handset or press hands-free key, please input “# * 111” button, then you can hear the IP
address voice information.
5.3 How to enter into web setting interface
Set the telephone through web interface.
 Connect the telephone and PC in the same LAN.
 Run the IE in the PC, and input the telephone IP in address bar.
 Input the User name and password, both of them are admin.
 Click Logon button to enter into the web setting interface.