User's Manual

10
8 Basic Function
8.1 Making Calls
In standby mode, you can make a call by:
 Enter the number and press the “C”
 Press “C” to enter the number, then press “C”
 IP direct dialing in standby:
 Set to the length of the IP address as the length of the received number
 Set the programmable button "*" key dial mode to DTMF input
 In standby mode, enter xxx*xxx*xxx*xxx and press “C” to call out.
8.2 Answering Calls
After setting up the automatic answer and setting up the automatic answer time, it will hear the
ringing bell within the set time and automatically answer the call after timeout. Cancel automatic
answering: when a call comes in, you will hear the ringing bell and it will not answer the phone
automatically over time.
When canceling the automatic answering, there are incoming calls that can be answered as
follows:
 Press the "*" button to answer (the default "*" button to answer, if you want to use the "#"
button to answer, you can use the programmable button to set)
 Press “C” to answer
8.3 End of the Call
You can hang up the call during the call by:
 Press “C” to hang up
 Press “#” to hang up (the default “#” key hangs up. If you want to hang up with “*” key, you
can set it by programmable button)
8.4 Auto-Answering
The user can turn off the auto-answer function (enabled by default) on the device webpage, and
the ring tone will be heard after the shutdown, and the auto-answer will not time out.

Web interface：enter [EGS Setting] >> [Features], Enable auto answer, set mode and
auto answer time and click submit.