User's Manual

14
Picture 10 - Multicast Settings
Table 5 - MCAST Parameters on Web
Parameters
Description
Enable Auto Mcast
The multicast configuration information is sent through Sip Notify
signaling. After receiving the information, the device will be
configured to the system for multicast monitoring or cancel
multicast monitoring in the system.
Delete
Time of Auto Mcast
Timeout
When a multicast call does not end normally, but for some reason
the device can no longer receive the multicast RTP packet, with
this configuration, the monitoring is cancelled after the specified
time.
Priority
Defines the priority in the current call, with 1 being the highest
priority to 10 the lowest.
Enable Intercom barge
into Mcast
When enabled, intercom insertion is allowed for multicast calls.
Enable Page Priority
The voice call in progress shall take precedence over all incoming
paging calls.
Name
Listened multicast server name
Host: port
Listened multicast server’s multicast IP address and port.
Multicast：
 Go to web page of [Function Key] >> [Function Key] , select the type to multicast, set
the multicast address, and select the codec.
 Click Apply.
 Set up the name, host and port of the receiving multicast on the web page of [Phone
Settings] >> [MCAST].