User's Manual

4
6 Appendix Table
6.1 Common command mode
Table 1 - Common command mode
Action
Description
IP Broadcast under
standby mode
In standby mode, long presse ‘#’
Switch network
mode
In standby mode, long press ‘C’ for 10 seconds, there will be a toot
sound. Within 5 seconds, press ‘C’ three times quickly to switch the
network mode. Network state in static or PPPoE mode will be
switched to DHCP mode; If the network is in DHCP mode, it will
switch to static IP 192.168.1.128. IP will be reported after
successful switch
6.2 Icon
Table 2 - Icon Status
Icon
Description
Icon
Description
Connect to the network
Network not connected，
flashing
Successfully registered
Registration failed, flashing
Ringing
Dialing
Call failed (no response)
Hang up by the other party
Lock off
Lock on
Dial interface lock
Dial interface lock is open
Open the door
Handsfree
Fault prompt 1
(with error number)
Fault prompt 2
(？: flashing)