Config Guide

65
Understand the call status by referring to 6.3 Appendix III –LED .
To facilitate private hold, configure keys whose DSS Key is Private Hold on the
Function Key page. Pay attention that the public hold key is the softkey-hold key
during a call.
Picture 77 - Set Private Hold Function Key

After each phone set registered with the BroadSoft server is configured as above,
the SCA function can be used.
2）LED Status
To facilitate viewing the call status of a group, configure lines whose DSS Key is SCA.
The following table describes the LEDs of lines in different states.
Table 12 - LED Status of SCA
State&Direction
Local
Remote
Idle
Off
Off
Seized
Steady green
Steady red
Progressing (outgoing call)
Steady green
Steady red
Alerting (incoming call)
Fast blinking green
Fast blinking green
Active
Steady green
Steady red
Public Held (hold)
Slow blinking green
Slow blinking red
Held-private (private hold)
Slow blinking yellow
Steady red
Bridge-active (Barge-in)
Steady green
Steady red
Bridge-held
Steady green
Steady red
3） Shared Call Appearance(SCA)