Config Guide

Learning

apply the learned VLAN ID to the phone configuration

QoS

QoS Mode

configure SIP DSCP and audio DSCP

WAN VLAN

WAN port VLAN configuration

LAN VLAN

LAN port VLAN configuration

CDP

CDP enable/disable ，CDP interval time

Note

：

QoS & VLAN details refer to

http://www.fanvil.com/Uploads/Temp/download/20180920/5ba383b56c3ef.pdf

11.7.2.3 VPN

Virtual Private Network (VPN) is a technology to allow device to create a tunneling

connection to a server and becomes part of the server’s network. The network

transmission of the device may be routed through the VPN server.

For some users, especially enterprise users, a VPN connection might be required to be

established before activate a line registration. The device supports two VPN modes,

Layer 2 Transportation Protocol (L2TP) and OpenVPN.

The VPN connection must be configured and started (or stopped) from the device web

portal.



L2TP

NOTICE! The device only supports non-encrypted basic authentication and

non-encrypted data tunneling. For users who need data encryption, please use

OpenVPN instead.

To establish a L2TP connection, users should log in to the device web portal, open

webpage [Network] >> [VPN]. In VPN Mode, check the “Enable VPN” option and select

“L2TP”, then fill in the L2TP server address, Authentication Username, and

Authentication Password in the L2TP section. Press “Apply” then the device will try to

connect to the L2TP server.

When the VPN connection established, the VPN IP Address should be displayed in the

VPN status. There may be some delay of the connection establishment. User may need

to refresh the page to update the status.