Config Guide

114
Add dialing rules:
Picture 132 - Custom setting of dial - up rules
Table 21 - Dial - up rule configuration table
Parameters
Description
Dial rule
There are two types of matching: Full Matching or Prefix Matching. In Full
matching, the entire phone number is entered and then mapped per the Dial
Peer rules.
In prefix matching, only part of the number is entered followed by T. The
mapping with then take place whenever these digits are dialed. Prefix mode
supports a maximum of 30 digits.
Note: Two different special characters are used.
 x -- Matches any single digit that is dialed.
 [ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges separated
by commas, or a list of digits.
Destination
Set Destination address. This is for IP direct.
Port
Set the Signal port, and the default is 5060 for SIP.
Alias
Set the Alias. This is the text to be added, replaced or deleted. It is an optional
item.
Note: There are four types of aliases.
 all: xxx – xxx will replace the phone number.
 add: xxx – xxx will be dialed before any phone number.
 del –The characters will be deleted from the phone number.
 rep: xxx – xxx will be substituted for the specified characters.