Config Guide

121
Display Missed Call Popup
No incoming call popup prompt after opening, no popup prompt
when closing, open by default.
Display MWI Popup
Voice message popup prompt is not answered after opening, and
it is opened by default if there is no popup prompt when closing.
Display Device Connect Popup
There is a popup prompt when the WIFI adapter is connected.
There is no popup prompt when the WIFI adapter is closed. It is
on by default.
Display SMS Popup
There is popup prompt for unread messages after opening, and
there is no popup prompt when closing. It is opened by default.
Display Other Popup
When the handle is not hung back after opening, registration fails,
IP acquisition fails, Tr069 connection fails and other
abnormalities, there will be popup prompt when it is opened;
otherwise, there will be no prompt when it is closed, and it will be
opened by default.
13.11 Phone settings >> Media Settings
Change voice Settings.
Table 26 - Voice settings
Parameter
Description
Codecs Settings
Select enable or disable voice encoding:
G.711A/U,G.722,G.723,G.729,
G.726-16,G726-24,G726-32,G.726-40,
ILBC,AMR,AMR-WB, Opus
Audio Settings
Handset Volume
Set the Handset volume, the value must be 1~9
Default Ring Type
Configure default ringtones. If no special ringtone is set for the
phone number, the default ringtone will be used.
Speakerphone Volume
Set the hands-free volume to 1-9.
Headset Ring Volume
Set the volume of the earphone ringtone to 1~9.
Headset Volume
Set the volume of the headset to 1~9.
Speakerphone Ring Volume
Set the volume of hands-free ringtone to 1~9.
G.723.1 Bit Rate
5.3kb/s or 6.3kb/s is available.
DTMF Payload Type
Enter the DTMF payload type, the value must be 96~127.
AMR Payload Type
Set AMR load type, range 96~127.
Headset Mic Gain
Set the earphone's radio volume gain to fit different models of