Config Guide

122
earphones.
Opus playload type
Set Opus load type, range 96~127.
OPUS Sample Rate
Set Opus sampling rate, including opus-nb (8KHz) and opus-wb
(16KHz).
ILBC Payload Type
Set the ILBC Payload Type, the value must be 96~127.
ILBC Payload Length
Set the ILBC Payload Length
Enable MWI Tone
When there is a new voice message message, the phone will start
a special dial tone.
Enable VAD
Whether voice activity detection is enabled.
Onhook Time
Configure a minimum response time, which defaults to 200ms
EHS Type
EHS headset is available after enabling.
RTP Control Protocol(RTCP) Settings
CNAME user
Set CNAME user
CNAME host
Set CNAME host
RTP Settings
RTP keep alive
Hold the call and send the packet after 30s
Alert Info Ring Settings
Value
Set the value to specify the ring type.
Ring Type
Type1-Type9
13.12 Phone settings >> MCAST
This feature allows user to make some kind of broadcast call to people who are in
multicast group. User can configure a multicast DSS Key on the phone, which allows
user to send a Real Time Transport Protocol (RTP) stream to the pre-configured
multicast address without involving SIP signaling. You can also configure the phone to
receive an RTP stream from pre-configured multicast listening address without involving
SIP signaling. You can specify up to 10 multicast listening addresses.
Table 27 - Multicast parameters
Parameters
Description
Normal Call Priority
Define the priority of the active call, 1 is the highest priority, 10 is the
lowest.
Enable Page Priority
The voice call in progress shall take precedence over all incoming
paging calls.
Name
Listened multicast server name