User's Manual

95
ILBC, Opus
Audio Settings
Handset Volume
Set the Handset volume, the value must be 1~9
Default Ring Type
Configure default ringtones. If no special ringtone
is set for the phone number, the default ringtone
will be used.
Speakerphone Volume
Set the hands-free volume to 1-9.
Headset Ring Volume
Set the volume of the earphone ringtone to 1~9.
Headset Volume
Set the volume of the headset to 1~9.
Speakerphone Ring Volume
Set the volume of hands-free ringtone to 1~9.
G.723.1 Bit Rate
5.3kb/s or 6.3kb/s is available.
DTMF Payload Type
Enter the DTMF payload type, the value must be
96~127.
AMR Payload Type
Set AMR load type, range 96~127.
Headset Mic Gain
Set the earphone's radio volume gain to fit
different models of earphones.
Opus playload type
Set Opus load type, range 96~127.
OPUS Sample Rate
Set Opus sampling rate, including opus-nb (8KHz)
and opus-wb (16KHz).
ILBC Payload Type
Set the ILBC Payload Type, the value must be
96~127.
ILBC Payload Length
Set the ILBC Payload Length
Enable MWI Tone
When there is a new voice message message, the
phone will start a special dial tone.
Enable VAD
Whether voice activity detection is enabled.
Onhook Time
Configure a minimum response time, which
defaults to 200ms
EHS Type
EHS headset is available after enabling.
RTP Control Protocol(RTCP) Settings
CNAME user
Set CNAME user
CNAME host
Set CNAME host
RTP Settings
RTP keep alive
Hold the call and send the packet after 30s
Alert Info Ring Settings
Value
Set the value to specify the ring type.
Ring Type
Type1-Type9