User's Manual

63

Second Outgoing Call
To make a second call, user may press [Xfer] / [Conf] button to make a new call on the
default line or press the line key to make new call on specific line. Then dial the number
the same way as making a phone call. Another alternative for making second call is to
press DSS Keys or dial out from the configured Keys (BLF/Speed Dial). When the user is
making a second call with the above methods, the first call could be held on manually or
will be held on automatically at second dial.

Switching between Two Calls
When there are two calls established, user will see a dual calls screen as the following
picture.
Picture 19 - Two way calling
User can press up/down navigator buttons to switch screen page, and switch call focus
by pressing [Resume] button.

Ending One Call
User may hang up the current talking call by closing the audio channel or press [End]
button. The device will return to single call mode in holding state.
10.3 End of the Call
After the user finishes the call, the user can put the handle back on the phone, press the
hands-free button or Softkey [End] key to close the voice channel and end the call.
Note! When the phone is in the reserved state, the user must press the [Resume]
key to return to the call state, or put the receiver back and press the hands-free
button to end the call.