User's Manual
Table Of Contents
- User Manual
- 1 Picture
- 2 Table
- 3 Safety Instruction
- 4 Overview
- 5 Install Guide
- 6 Appendix Table
- 7 Introduction to the User
- 8 Basic Function
- 9 Advance Function
- 10 Phone Settings
- 11 Web Configurations
- 12 Network >> Basic
- 12.1 Network >> Service Port
- 12.2 Network >> Advanced
- 12.3 Line >> SIP
- 12.4 Line >> SIP Hotspot
- 12.5 Line >> Dial Plan
- 12.6 Line >> Action Plan
- 12.7 Line >> Basic Settings
- 12.8 Line >> RTCP-XR
- 12.9 Phone settings >> Features
- 12.10 Phone settings >> Media Settings
- 12.11 Phone settings >> MCAST
- 12.12 Phone settings >> Action
- 12.13 Phone settings >> Time/Date
- 12.14 Phone settings >> Tone
- 12.15 Phone settings >> Advanced
- 12.16 Phonebook >> Contact
- 12.17 Phonebook >> Cloud phonebook
- 12.18 Phonebook >> Call List
- 12.19 Phonebook >> Web Dial
- 12.20 Phonebook >> Advanced
- 12.21 Call Logs
- 12.22 Function Key >> Function Key
- 12.23 Function Key >> Softkey
- 12.24 Function Key >> Advanced
- 12.25 Application >> Manage Recording
- 12.26 Security >> Web Filter
- 12.27 Security >> Trust Certificates
- 12.28 Security >> Device Certificates
- 12.29 Security >> Firewall
- 12.30 Device Log >> Device Log
- 13 Trouble Shooting
- FCC 一般产品警示语 大于20cm
SIP signaling. You can specify up to 10 multicast listening addresses.
Table 29 - Multicast parameters
Parameters Description
Normal Call Priority
Define the priority of the active call, 1 is the
highest priority, 10 is the lowest.
Enable Page Priority
The voice call in progress shall take precedence
over all incoming paging calls.
Name Listened multicast server name
Host: port
Listened multicast server’s multicast IP address
and port.
12.12 Phone settings >> Action
Action URL
Note! Action urls are used for IPPBX systems to submit phone events. Please refer
to Fanvil Action URL for details.
http://www.fanvil.com/Uploads/Temp/download/20180920/5ba3641fe81a5.pdf
12.13 Phone settings >> Time/Date
The user can configure the time Settings of the phone on this page.
Table 30 – Time & Date settings
Parameters Description
Network Time Server Settings
Time Synchronized via SNTP Enable time-sync through SNTP protocol
Time Synchronized via DHCP Enable time-sync through DHCP protocol
Primary Time Server Set primary time server address
Secondary Time Server Set secondary time ser
ver address, when
primary server is not reachable, the device will
try to connect to secondary time server to get
time synchronization.
Time Zone Select the time zone
Resync Period Time of re-synchronization with time server
135