User's Manual
Table Of Contents
- User Manual
- 1 Picture
- 2 Table
- 3 Safety Instruction
- 4 Overview
- 5 Install Guide
- 6 Appendix Table
- 7 Introduction to the User
- 8 Basic Function
- 9 Advance Function
- 10 Phone Settings
- 11 Web Configurations
- 12 Network >> Basic
- 12.1 Network >> Service Port
- 12.2 Network >> Advanced
- 12.3 Line >> SIP
- 12.4 Line >> SIP Hotspot
- 12.5 Line >> Dial Plan
- 12.6 Line >> Action Plan
- 12.7 Line >> Basic Settings
- 12.8 Line >> RTCP-XR
- 12.9 Phone settings >> Features
- 12.10 Phone settings >> Media Settings
- 12.11 Phone settings >> MCAST
- 12.12 Phone settings >> Action
- 12.13 Phone settings >> Time/Date
- 12.14 Phone settings >> Tone
- 12.15 Phone settings >> Advanced
- 12.16 Phonebook >> Contact
- 12.17 Phonebook >> Cloud phonebook
- 12.18 Phonebook >> Call List
- 12.19 Phonebook >> Web Dial
- 12.20 Phonebook >> Advanced
- 12.21 Call Logs
- 12.22 Function Key >> Function Key
- 12.23 Function Key >> Softkey
- 12.24 Function Key >> Advanced
- 12.25 Application >> Manage Recording
- 12.26 Security >> Web Filter
- 12.27 Security >> Trust Certificates
- 12.28 Security >> Device Certificates
- 12.29 Security >> Firewall
- 12.30 Device Log >> Device Log
- 13 Trouble Shooting
- FCC 一般产品警示语 大于20cm
Picture 18 - Two way calling
User can press up/down navigator buttons to switch screen page, and switch call focus
by pressing [Resume] button.
Ending One Call
User may hang up the current talking call by closing the audio channel or press [End]
button. The device will return to single call mode in holding state.
8.3 End of the Call
After the user finishes the call, the user can put the handle back on the phone, press the
hands-free button or Softkey [End] key to close the voice channel and end the call.
Note! When the phone is in the reserved state, the user must press the [Resume]
key to return to the call state, or put the receiver back and press the hands-free
hook to end the call.
8.4 Video Call
X7A supports a variety of video formats CIF, VGA, 4CIF, 720P.
The device only supports video decoding, but users can initiate video calls.
The default dialing mode is video. When the device dials, it USES video mode to call
out by default. If the end device supports sending video, both sides establish video
call.
The default dialing mode is voice. The above operation establishes voice call
33