User Manual

10 11
OPERATION
• Ensure the Battery Pack is fully inserted and locked in place in the Battery
Docking Port.
• Connect the Jack Adaptor to the
Charger Socket and then the Charger
into a wall outlet (ill.
j
). The Indicator
Lights will flash for 10 seconds before
showing the actual battery status (
Indicator lights).
NOTE:
- The capability to charge the Battery
Pack is not affected by the appliance
state of assembly.
• Disconnect the Charger from the wall
outlet and then the Jack Adaptor from
the Charger Socket.
j
1.
2.
Indicator lights
Below table shows the dierent combinations of Indicator Lights.
Indicator lights Color State Remarks
1 ashing light
Blue
Charging
Battery level ≤ 25%
1 steady light and
1 ashing light
25% ≤ Battery level < 50%
2 steady lights and
1 ashing light
50% ≤ Battery level < 75%
3 steady lights and
1 ashing light
75% ≤ Battery level < 100%
4 steady lights
Plugged with full charge
In use
75% ≤ Battery level < 100%
3 steady lights 50% ≤ Battery level < 75%
2 steady lights 25% ≤ Battery level < 50%
1 steady light
Red
Battery level ≤ 25%
1 ashing light
Fault
Battery Pack needs charging
4 ashing lights
Defective Battery Pack, blocked motor or
Battery Pack charging issue
No light None
Not in
use
Unplugged appliance / Depleted or missing
Battery Pack
OPERATION
Blending programs
The maximum blending times in the chart below are not approximate and should
be respected.
Button Duration Speed Action
PULSE max. 1 minute max speed
Rotate counterclockwise and hold;
release to stop
HIGH
max. 1 minute
high speed
Rotate clockwise to start; rotate
counterclockwise to OFF position to stop
LOW slow speed
NOTE:
- Do not operate the appliance continuously for more than 1 minute. Do not
operate the appliance continuously for more than 15 seconds without load.
Allow the appliance to cool down for 3 minutes before using it again.
- If used for 1.5 minutes, the appliance will switch off automatically. Allow the
appliance to cool down for 5 minutes before using it again.
- Turn the Control Knob (PULSE OFF HIGH LOW) to OFF position to stop
operation and switch the appliance off.
Tips for ice crushing: When crushing ice, always add water until ice oats over the
blades. (Do not use anything except water to crush ice.)
Charging the Battery Pack
The Battery Pack for this appliance has been shipped in a low charge condition.
Charge it fully before rst use.
NOTE:
- The Battery Pack has a rated voltage of DC 14.8V. Before plugging the
charger into a wall outlet for charging, ensure that the electrical circuit is not
overloaded with other appliances.
WARNING:
- Charge in a safe location away from moisture and heat sources!
- Always charge the Battery Pack before storage!
Rechargeable Blender_BL 45312_IM_US_V10_190610.indd 11 6/10/19 10:24 AM