Use and Care Guide

Grounding Instructions:

This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk

of electric shock by providing a path of least resistance for the electric current. This appliance is

equipped with a cord having an equipment-earthing conductor and an earthing plug. The plug must be

plugged into an appropriate outlet that is installed and earthed in accordance with all local standards and

requirements.

WARNING! Improper connection of the equipment earthing conductor can result in the risk of an

electric shock. Check with a qualified electrician or service representative if you are in doubt whether the

appliance is properly earthed. Do not modify the plug provided with the appliance. If the plug does not fit

properly to the outlet, please have a qualified electrician to install a proper outlet.

Water Connection

Cold water connection

Please take frost protection measures on dishwasher in winter. Each time after washing cycles, please

operate as follows:

Connect the cold water supply hose to a threaded 3/4(inch) connector and make

sure that it is fastened tightly in place. If the water pipes are new or have not been

used for an extended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken, there is a risk

that the water inlet can get blocked and damage the appliance.

Please Note: If the supplied hose does not fit your tap, please contact your local

plumbing supply center where adapters are available for purchase.

WARNING! please close the faucet after using.

1. Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use Teflon tape to eliminate

if necessary).

2. Connect the six-sided connection of the drain hose to the drain port connection on the back of the

dishwasher cabinet. Do not over-tighten (to avoid damage to threads).

3. Connect the star-shaped connection of the inlet hose to the inlet port on the back of the

dishwasher cabinet. Do not over-tighten (to avoid damage to threads).

4. Connect the circular connection of the drain hose onto the longer (bottom) male connection on the

quick connect.

5. Connect the circular connection of the inlet hose onto the shorter (top) male connection on the

quick connect.