Instruction Manual

IRONING WITH STEAM

When using as a Steam Iron, be sure the temperature setting on the

Temperature Control Dial is within the STEAM range to avoid water

spotting on a garment.

1. Position Temperature Control Dial to the lowest MIN setting.

2. Turn the Variable Steam Dial to NO STEAM.

3. With the unit UNPLUGGED, fill the Iron's Water Tank. (See

FILLING THE WATER TANK instructions.)

4. Stand the Iron on its Heel in an upright position on an iron-safe

surface and plug it in.

5. Turn the Temperature Control Dial to the COTTON/LINEN

setting.

6. Allow approximately 2 minutes for the Iron to reach the desired

temperature.

7. Turn the Variable Steam Dial to for Moderate Steam or

for Maximum Steam. As soon as the Iron is held horizontally,

steam will flow through the Vents. If the iron fails to steam,

gently tap the Soleplate on the Iron surface. Placing the Iron on

its Heel in an upright position interrupts the flow of steam.

8. When finished, turn the Temperature Control Dial to MIN and

unplug. Allow Iron to cool fully before cleaning the exterior of

the Iron or before storing.

CAUTION: Avoid coming into contact with escaping steam.

BURST OF STEAM

The “Burst of Steam” is very useful for

removing stubborn creases from fabrics.

1. Fill Water Tank and set Temperature

Control Dial to either the COTTON or

LINEN setting.

2. Press down on the Burst of Steam

Button.

NOTE: If the temperature setting is too low, water may drip from

Soleplate. To obtain a good flow of steam, press Burst of Steam

Button several times, pausing 5 seconds between each burst to

allow Iron to reheat.

Burst of Steam/

Spray Button