- FARGO Electronics Single-Side Printer User Guide
Table Of Contents
- Supported Linux Distributions
- Installation Procedures
- Printing a Sample Card
- Printer Maintenance
- Driver Options
- Using the Device Options
- Print and Overlay Options
- Magnetic Encoding Options
- Sending ISO Magnetic Encoding Information
- Sending JIS II Magnetic Encoding Information
- Sending RAW Magnetic Encoding Information
- Reviewing the URL Encoding Reference
- Reviewing the ASCII Code and Character Table
- Using the Image Color Capabilities
- Using the Image Position Function
Fargo M30e CUPS Driver User Guide (Rev. 1.0.3)
12
Reviewing the File Listing
/usr/share/cups/model/M30e.ppd
PPD File for the M30e Card Printer
/usr/lib/cups/filter/rastertofargoM30e
Raster Filter for the M30e Card Printer
/usr/share/fargo/M30e/M30eTst.prn
Test Print file
/usr/ share/fargo/M30e /RibbonCal.prn
Ribbon Sensor Calibration File
/usr/ share/fargo/M30e/CleanPrinter.prn
Clean Printer File
Printing a Sample Card
Entering the Print Only Command
Run the following command:
# lp –d [PrintQueueName] [filename]
Entering the Print with Mag Encoding Command
Run the following command:
# lp –d [PrintQueueName] –o “Magtrack1=%25MAGTEST1%3F
Magtrack2=%3B1234567890%3F Magtrack3=%3B1234567890%3F” [filename]