- FARGO Electronics Single-Side Printer User Guide
Table Of Contents
- Supported Linux Distributions
- Installation Procedures
- Printing a Sample Card
- Printer Maintenance
- Driver Options
- Using the Device Options
- Print and Overlay Options
- Magnetic Encoding Options
- Sending ISO Magnetic Encoding Information
- Sending JIS II Magnetic Encoding Information
- Sending RAW Magnetic Encoding Information
- Reviewing the URL Encoding Reference
- Reviewing the ASCII Code and Character Table
- Using the Image Color Capabilities
- Using the Image Position Function
Fargo M30e CUPS Driver User Guide (Rev. 1.0.3)
13
Printer Maintenance
Performing a Ribbon Sensor Calibration
Step
Description
1
Remove all cards from the Card Hopper and close the Hopper door.
2
Open the Front Cover, remove the Ribbon Cartridge and close the Printer’s
front cover.
3
Place a notebook or a completely opaque sheet of paper in front of the
Printer to block the ambient light.
4
From a terminal window enter:
lpr -l “/usr/share/fargo/M30e/RibbonCal.prn”
5
When completed, the Printer will beep twice.