- FARGO Electronics Single-Side Printer User Guide
Table Of Contents
- Supported Linux Distributions
- Installation Procedures
- Printing a Sample Card
- Printer Maintenance
- Driver Options
- Using the Device Options
- Print and Overlay Options
- Magnetic Encoding Options
- Sending ISO Magnetic Encoding Information
- Sending JIS II Magnetic Encoding Information
- Sending RAW Magnetic Encoding Information
- Reviewing the URL Encoding Reference
- Reviewing the ASCII Code and Character Table
- Using the Image Color Capabilities
- Using the Image Position Function
Fargo M30e CUPS Driver User Guide (Rev. 1.0.3)
30
Following the Resin Heat Back Procedure
Command Line
Usage
CUPS option
Description
ResinHeatBack =
0
<-100 to 100>
Resin Heat Back (K) = 0
1. Adjust the Resin Heat Back value
higher to use more heat and
increase the transfer of resin to a
card.
2. Adjust the Resin Heat Back value
lower to reduce the amount of heat
used and reduce the transfer of
resin to the card.
Following the Overlay Heat Procedure
Command Line
Usage
CUPS option
Description
OverlayHeat = 0
<-50 to 50>
Overlay Heat (O) = 0
1. Adjust the Overlay Heat value
higher to use more heat and
increase the transfer of overlay to a
card.
2. Adjust the Overlay Heat value lower
to reduce the amount of heat used
and reduce the transfer of overlay to
the card.