Installation Guide

hidglobal.com
An ASSA ABLOY Group brand
FARGO® HDP®6600
Lamination Module
PLT-04395, Rev A.1
© 2019 HID Global Corporation/ASSA ABLOY AB. All rights reserved. This document may not be reproduced, disseminated or republished in any form without the prior written
permission of HID Global Corporation. HID GLOBAL, HID, the HID Brick logo, the Chain Design, FARGO, and HDP are trademarks or registered trademarks of HID Global, ASSA
ABLOY AB, or its aliate(s) in the US and other countries and may not be used without permission. All other trademarks, service marks, and product or service names are
trademarks or registered trademarks of their respective owner.
INSTALLATION GUIDE
Remove the output bin from the printer (if
attached).
Move the blue lever on the lamination
module down. Align the posts and slide the
lamination module into place. Move the blue
lever up to lock.
Replace the printer and lamination module
access covers.
Remove the access cover from the printer.
Connect the lamination cable to the
printer connector (labeled pink).
Connect the power cords to the printer
and the lamination module.
Remove the access cover from the
lamination module.
Attach the output hopper supplied with
the lamination module. Do not use the
output hopper supplied with the printer.
Connect the USB/Ethernet cables to the
printer (as required) and switch on the
printer.
7
6
9
1
8
54
32
Installation to a HDP6600 (without a Dual Side Module)
Follow these instructions to connect the HDP6600 Lamination Module directly to a
HDP6600 printer, without a Dual Side Module. Alternatively, scan the QR code or visit
http://hid.gl/HDP6600-Lam-upgrade-SS to view the installation video. Refer to the other
side of this sheet if you have a Dual Side Module.
Before you begin:
 Download and install the latest HDP6600 printer driver and firmware from
https://www.hidglobal.com/drivers
 Switch o the printer and unplug the power cord
 Unplug any USB and Ethernet cables from the printer