User Guide

30
4.5.2 Network Settings
DriveClone can back up to, or restore from a network location. To
use this feature, you should first configure your network settings.
To configure your network settings, click Settings from the main DriveClone
interface and then click the Settings button in under Network.
There are two tabs in the Network Settings window:
¾ General:
The General tab is shown below.
You can setup your network adaptor, IP address, Subnet mask and Default
gateway from here.
If you have more than one network adaptor on your system, select the
adaptor to be used from the dropdown menu.
IP Settings:
z Obtain an IP address automatically: If your network supports
DHCP (Dynamic Host Configuration Protocol), choose this option to
obtain an IP address automatically from a DHCP server or a
Point-to-Point Protocol (PPP) dial-up network access server.
DriveClone uses DHCP as the default option and will obtain the IP
address of your computer automatically.
z IP address: Choose this option to manually specify IP address for
your network. This option can be used when automatically
obtaining IP address fails or the there is an IP address conflict.
¾ Advanced
The Advanced tab is shown as below.