Use and Care Guide

Use and Care Instructions for
Glue-Up Ceiling Panels
How do I need to prepare the ceiling before I install the glue up tiles?
If you are planning to install glue up tiles to your ceiling, you need to make sure your ceiling is clean. We recommend
that you apply a fresh coat of primer or paint on the ceiling before the panels are installed. Also, be sure to clean the
back of each panel with rubbing alcohol before applying adhesive. Acceptable substrates are drywall, plaster or clean,
smooth tile (glazed, porcelain type tile; not porous or textured). Any damaged, loose or uneven areas must be repaired,
patched, leveled and primed. Fill cracks and irregularities with wallboard compound or spackling, then sand smooth with
fine-grade sandpaper. Any porous material like highly textured drywall, plywood (or any raw wood without primer), and
wallpaper unless removed, sanded and primed, will result in adhesive failure.
What can I use to cut the ceiling tiles?
To cut the ceiling tiles use a utility knife, scissors or a tin snips.
What kind of adhesive do I need to install the glue-up panels?
The preferred method for installing Glue-Up ceiling panels is to apply the adhesive directly to the back of the panels.
Then use use a notched trowel (1/4″ x 1/4″ x 3/4″) and spread the adhesive evenly on the panel. ACP, the manufacturer
of Fasade recommends using Loctite PL Premium adhesive. Do not use double-sided tape to install ceiling panels.
If I choose to use the Tube Adhesive, how much do I need to purchase?
When gluing up the ceiling panels, you will need 1 (10.5 oz) tube for two 2’x4’ tiles.