Manual

p7
© Fast & Fluid Management, EuroAT
Safety Instructions
General safety instructions
Attention! Before installing the equipment and setting it in operation,
please read the instructions for use carefully. This is safer for yourself and
prevents unnecessary damage to the machine.
The manufacturer accepts no liability if the instructions below are not followed:
1.
If a machine has been damaged (during transport, for example), do not attempt to set it in operation.
When in doubt, first contact either your supplier or the F&FM service departm ent.
2.
The equipment should be positioned and connected up in strict acc ordance with the installation
instructions.
3.
All local safety regulations and ordinances should be observed.
4.
The machine may be connected only to a 230V/16A/50Hz or 100-110V/25A/50-60HZ earthed wall socket
installed in accordance with the regulations.
5.
Users should see to it that the machine is kept in good condition. Defective components should be replaced.
6.
In order to prevent physical injury, the doors should be closed and the paneling fitted during norm al use.
7.
All service activities (other than routine maintenance and adjustments) may only be carried out by qualified
technicians. See to it that the mains lead is always kept unplugged while repairs are being carried out.
8.
Because of the design of the valve, a nozzle drill may never be used. Cleaning is done by running the
cleaning program.
Specific warnings in this manual
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power
before accessing moving parts.
Each line in the machine (pumps and tubing) is tested with water. If your
application is not compatble with water please rinse intensely with an
appropriate fluid.