Installation Guide

IBR Installation Guide
Page 24 of 38 Doc # 770-00023.1
Jan. 23, 2015
The connector will work with CAT5E and CAT6 cables and other cables having an outer diameter between 5.0
and 6.0 mm. NOTE: Use only weatherproof, shielded cable.
To install the GT225360-00 connector and RF-45 plug on a shielded cable:
 Strip the cable jacket 12.0 mm.
 Thread the cable through the connector components in the order shown in the diagram above.
 Install the RJ-45 plug.
- Untwist the individual strands.
- Insert the cables into the RJ-45 plug in the order shown below.
1. White/orange 5. White/blue
2. Orange 6. Green
3. White/green 7. White/brown
4. Blue 8. Brown
- Wrap the ground wire around the cable jacket underneath the back of the RJ-45 plug.
- Crimp the plug using a crimping tool.
 Assemble the GT225360-00 connector, tightening the gland nut to within 0.6 – 0.7 ft-lb (9.0 – 10.0 kgf-
cm).
Connectors may be obtained from Fastback or directly from the manufacturer:
Model: GT225360-00
Supplier: GT Contact Co. LTD.
The images below illustrate assembly of the RF-45 plug.
1. 2.
3. 4. 5.