Installation Guide

IBR Installation Guide
Page 38 of 38 Doc # 770-00023.1
Jan. 23, 2015
Federal Communications Commission (FCC) Compliance Statement
The equipment that is the subject of this Guide has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is properly
installed and operated in accordance with instructions contained in this manual. In addition, this
equipment complies with FCC radiation exposure limits for operation in an uncontrolled
environment.
The equipment should not be operated if it becomes out of compliance with FCC Rules. In order to
ensure continued compliance with FCC Rules, the equipment:
 Should be installed in a restricted area that is accessible only by authorized service
personnel.
 Should not be operated within one hundred centimeters (100 cm) of personnel.
 Should not be operated if it is or becomes damaged.
 Should be connected to other devices by shielded cables of the correct types.
 Should not be repaired or modified except by Fastback Networks.
This device complies with part 15 of FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Return to Table of Contents