User's Manual

FAST Bin℠ User Manual
Fastenal Company FAST Bin℠ User Manual Page | 16
Revision 4.0
Compliance Information
The following compliance information applies to the Controller, Reader, and Repeater devices.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any
interference that may be received or that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the user manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his
own expense.
Canadian (IC) Statement of Compliance
This device complies with RSS-247 of the Industry Canada rules. Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference that may be received or that may cause undesired operation.
Cet appareil est conforme à la norme RSS-247 des règles d'Industrie Canada. Le fonctionnement
est soumis à deux conditions: (1) Cet appareil ne doit pas causer d'interférences nuisibles, et (2)
cet appareil doit accepter toute interférence qui pourrait être reçue ou qui pourrait causer un
fonctionnement indésirable.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm
between the radiator and all persons.