Manualshelf

Dimensions Guide

ManualsBrandsFastenMaster ManualsFasteners#0 x 6-in Black Ecoat Flat-Head Interior/Exterior Structural Wood Screws (12-Count)
12345678910
ESR-1078
|
Most Widely Accepted and Trusted Page 5 of 8
THRULOK NUT (TOP) AND
WASHER (BOTTOM)
TABLE 1E—FASTENER SPECIFICATIONS: TRUSSLOK-Z FASTENERS
TRUSSLOK-Z
®
FASTENER
DESIGNATION
HEAD
MARKING
OVERALL
LENGTH
1
(inches)
LENGTH OF
THREAD
2
(inches)
UNTHREADED
SHANK
DIAMETER
(inch)
MINOR THREAD
(ROOT)
DIAMETER
(inch)
BENDING
YIELD
3
(F
yb
, psi)
ALLOWABLE
FASTENER STRENGTH
Tensile
(lbf)
Shear
4
(lbf)
TSLZ278
F2.8
2
7
/
8
1
1
/
4
0.228
0.202
218,400
1,833
1,235
TSLZ412
F4.5
4
1
/
2
TSLZ006
F6.0
6
For SI: 1 inch = 25.4 mm, 1 lbf = 4.4 N, 1 psi = 6.895 kPa.
1
For purposes of measuring overall fastener length, fasteners must be measured from the underside of head to bottom of tip.
2
Length of thread includes tip. See detailed illustration.
3
Bending yield strength determined per methods specified in ASTM F1575 and based on the minor thread diameter.
4
Allowable shear strength values apply only to shearing in the unthreaded shank portion of the fastener.
TABLE 1F—FASTENER SPECIFICATIONS: THRULOK FASTENERS
6
THRULOK
®
FASTENER
DESIGNATION
HEAD
MARKING
OVERALL
LENGTH
1
(inches)
LENGTH OF
THREAD
2,4
(inches)
UNTHREADED
SHANK
DIAMETER
(inch)
MINOR THREAD
(ROOT)
DIAMETER
(inch)
BENDING
YIELD
3
(F
yb
, psi)
ALLOWABLE
FASTENER STRENGTH
Tensile
(lbf)
Shear
5
(lbf)
A
B
THR614
FT6.2
6
1
/
4
5
/
9
1
2
/
10
0.228
0.201
218,400
1,970
1,235
THR007
FT7.0
7
THR008
FT8.0
8
THR912
FT9.5
9
1
/
2
For SI: 1 inch = 25.4 mm, 1 lbf = 4.4 N, 1 psi = 6.895 kPa.
1
For purposes of measuring overall fastener length, fasteners must be measured from the underside of head to bottom of tip.
2
Length of thread includes tip. See detailed illustration.
3
Bending yield strength determined per methods specified in ASTM F1575 and based on the minor thread
diameter.
4
The thread lengths given for the ThruLOK are for zones A and B, as depicted in the diagram below.
5
Allowable shear strength values apply only to shearing in the unthreaded shank portion of the fastener.
6
The ThruLOK fastener must be used with the ThruLOK washer and nut (supplied with the fastener).