User guide

OPERATING INSTRUCTIONS
Roseville, MN
Phone: [phone]
Fax: [phone]
www.fastestinc.com
WP060 10/6/2010
MBE CONNECTOR
MBE CONNECTOR
W/TEST PIECE
MBE CONNECTOR W/TEST
PIECE INSERTED
SLEEVE
TEST PIECE
TEST PIECE
INSERTED
SLEEVE FORWARD
Operating Instructions for MBE Connectors
Note: Sleeve styles may change but operation is constant.
OPERATION:
1. Move the sleeve backwards to disengage the connector.
2. Place male end of test piece into the connector and make sure it is
completely inserted. Move the sleeve forward to engage the connector into
the part.
3. Slightly pull the back of the connector to insure engagement before testing.
Do not pull back on the sleeve after engagement.
4. These connectors will have proper engagement when the sleeve is
completely forward over the connectors body. Improper engagement can
result in loss of media and/or injury.
CAUTION:
 The maximum rated pressure is 500 psi. Before using, verify that this
pressure rating is within your working pressures.
 These connectors are not internally valved. Disconne
ct while pressurized
can cause rapid separation and high velocity loss of media.
 These connectors are designed for temporary connecti
ons and must be fully
mated to seal. Inadvertent loosening and loss of media can result when
used as permanent connections.
TO DISCONNECT FROM SEAT:
Deactivate the test pressure. Move connector’s sleeve backwards to
disengage. Remove connector from test piece.
MAINTENANCE:
 Periodically inspect connector and seal for proper operation. Replace or
repair parts as required to assure positive sealing and performance.
 Establish a regular interval of lubrication. The media and environment will be
determining factors in establishing this interval to prevent dryness and/or
corrosion.
 NOTE: Difficulty of operation after continual use indicates need for
lubrication or other maintenance. Repair parts, instructions and tools are
available. Please contact your FasTest Distributor or the Factory for
assistance.
FasTest, Inc. Product Warranty
FasTest, Inc. warrants its products against defects
of workmanship and/or material for 12 months from the
date of the sale by FasTest, Inc. This warranty is void if the product is misused, tampered with or used in a
manner that is not in accordance with FasTest, Inc. recommendations and/or instructions. FasTest, Inc. is
not liable for consequential or other damages including, but not limited to, loss, damage, personal injury, or
any other expense directly or indirectly arising from the use of or inability to use its products either
separately or in combination with other products. ALL OTHER WARRANTIES EXPRESSED OR IMPLIED,
WHETHER ORAL OR WRITTEN, INCLUDING BUT NOT LIMITED TO WARRANTIES OR
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY EXCLUDED.
Remedy under this warranty is limited to replacement of the product or an account credit in the amount of
the original selling price, at the option on FasTest, Inc. All allegedly defective products must be returned
prepaid transportation to FasTest, Inc. along with information describing the products performance, unless
disposition in the field is authorized in writing by FasTest, Inc.