Specification

575 Broadhollow Road (Rt. 110), Farmingdale, NY 11735 Tel: [phone] Fax: [phone] Email: [e-mail] Website: www.richterrevo.com
PREPARATION
Before application it may be necessary to clean, brush, or degrease any surface of dust or oils. To obtain
optimum adhesion, the bonding surfaces must be clean, dry and well unied. Some typical surface cleaning
solvents are isopropyl alchohol or N-heptane. Note: Carefully read and follow the manufacturer’s precatutions
and directions for use when working with solvents. It is recommended to acclimate the Stone-Veneer sheet
and the work object for at least 24 hours to avoid potential damage due to tension and/or warping. Ideal tape
application temperature rage is 70 degrees F to 100 degrees F (21 degrees C to 38 degrees C). Initial tape
application to surfaces at tehmperatures 50 degress f (10 degrees C) is not recommended because the adhesive
becomes to rm to adhere correctly. However, once properly applied, low temperature holding is generally
satisfactory.
INSTALLATION
Installation of FastStone+ is quick, simple and easy. When FastStone+ is applied, it is almost impossible to
remove or re-adjust the sheet from the object without damage. To apply the panels, it is recommended to start at
the top corner and work your way down. It is a must to follow a straight line and even line. To press the sheets
onto the surface, it is recommended to use a felt or rubber roller.
FLEXIBILITY
FastStone+ can be used in many of the same applications as other thin laminate products are used. It will bend
to a minimum 8” radius depending on the stone colour or type. With the assistance of heat, smaller radii can be
achieved. Testing should always be done prior to any installation. FastStone+ can be bent inward or outward to
meet a given look or architecture. Fiberglass strand is used in the makeup of FastStone+, which gives it superior
strength and exibility.
SEALERS & IMPREGNATORS
FastStone+ has been pre-treated with a leading brand stone sealer.
Please visit www.moellerstonecare.eu, www.lithon.com, www.akemi.com, www.laticrete.com, or your local
dealer.
LAYOUT & PATTERNS
Preparation of the area to be covered and the layout of the FastStone+ sheets is the same as for natural stone
or tile. Time spent preparing the work area will pay o immensely. A preliminary dry t of FastStone+ allows
for arrangements and orientation of individual sheets, patterns, textures, and colours before nal placement.
It is recommended that each sheet be dry t exactly where it will be placed on horizontal or vertical surfaces.
Numbering the sheets to track relocation before cutting and trimming is recommended and will save time.