Instructions / Assembly

GLD Products RENO II 7.5’ Pool Table
Item 64-0126
8 1-800-225-7593
www.gldproducts.com
STEP 1 - ASSEMBLE THE APRONS
1. Place the four apron side pieces (#3 and #4) in position. They should be upside down.
2. Use an angle bracket (#11) in each corner. Finger start four bolts (#14) with washers
(#19) through the angle bracket and into two of the apron pieces.
3. Repeat in all four corners.
4. Tighten all the bolts (wrench #23). When tightening the bolts, be certain the two pieces
are properly lined up at the corners.
STEP 2 - ASSEMBLE LEG BRACKET
1. Install one leg mounting bracket (#12) in each corner. Use four bolts (#14) with washers
(#19). Finger start all the bolts. Note that the flat part of the bracket will be up and even
with the side aprons.
2. Hold the bracket in position and tighten all the bolts (wrench #23).
#14
#19
#11
#3
#4
#3
#4
#14
#19
#12